Analog Man 3 Knob Small CompROSSor Compressor Pedal – REV4 – Ryck Toggle Option

$259.00

kxwj8banv5rffxasupna
Categories: , . Tag: .

1 in stock

Product Description

Analog Man 3 Knob Small CompROSSor Compressor Pedal – REV4 – Ryck Toggle Option

Analog Man makes the finest guitar compressor pedals including the 3 Knob Small Comprossor with added Attack Knob. This is based on the ROSS compressor but with several improvements we have made over the years, including an external ATTACK control knob.

In April, 2013 we really improved the COMPROSSOR circuit. Mike had been playing in a band for a few years, and noticed that SOME pedals on his board would not drive a load well, they would get dark and dull, due to a bad (high) output impedance. This is easily tested by running pedals into something like a low impedance volume pedal, with a switchable buffer between them. The ARDX20 with the delay level down is excellent for testing – when ON it’s a great buffer, when OFF it’s true bypassed. To test a pedal, simply turn the buffer on and off and listen for a change in tone. With most pedals, like our Chorus, Juicer, etc, there is no difference – they can drive the signal to your amp through long cables or volume pedals no problem. But the Comprossor sounded dull when the buffer was removed. The original Ross, Dynacomp, and all the other Ross clones do the same exact thing- they really need a buffer after them to sound good.

Also these pedals don’t have a very loud output, especially when you hit them hard, for example with humbuckers or a boosted signal. One other problem all these pedals have is phase reversal – they flip the phase of your signal when you turn them ON. This may not be a problem for most people, but if you split your signal and combine it, or run into two amps, the out of phase signals will cancel and you will get a VERY thin sound. Also, for use as a clean boost, there was too much compression even with the SUSTAIN pot all the way down. So we reduced the minimum compression amount, without changing the maximum amount. Now the pedal is more usable as a clean boost, and also sounds great left on all the time as a tone sweetener/buffer. It’s great stacked into dirt pedals, chorus, vibes, etc now. With these problems fixed, there is no need for a blend knob, you should be able to keep your pure tone without the need for additional circuitry. One other thing we improved was the LED circuitry. Now, if one side of the bicomp/mini bicomp is ON, and you turn the other side ON, the first LED does not get dimmer. A small change but something that bothered us. The REV4 boards are usually blue as seen in this picture of the BICOMP.

The Dynacomp and Ross circuit is not very bright, to keep white noise down. But sometimes it’s nice to have a bright trebly tone, as heard on Rickenbacker guitar’s built-in compressor. Looking at the Rickenbacher schematic, it’s about the same as the Dyna/Ross except it allows more treble for that jingle-jangle sound. We decided to offer this with a three-way switch so you can get just the amount of treble you want. One position is the normal Dynacomp/Ross value for about the same tone as OFF and low noise. The second position adds a bit more treble and just a touch of noise – this may be great to use all the time with a dark guitar like a Les Paul with high output pickups. The third position is twice as bright, close to the Rickenbacker setting, for a sound that really pops, with a bit of noise that you won’t notice till you stop playing. We can put this toggle on any of our new CompROSSor or Dynacomp pedals when ordered, or we can add it later on which costs a bit more as it’s more work to add it after the pedal is built.

Additional Information

Weight 2 lbs

Product Categories